Your cart is empty.
Your cart is empty. CV Boot Clamps
▪ Material: 304 Stainless Steel(long durability and reliability)
▪ Quantity: 4 pieces small crimp bands + 4 pieces big crimp bands
▪ Big Clamp: Length 17.13 in. Width 0.31 in. Maximum diameter 4.72 in.
▪ Small Clamp: Length 7.6 in. Width 0.31 in. Maximum diameter 1.81 in.
▪ Bearing Temperature: Max. 800℃
▪ Tensile Strength: Max. 520 MPa
▪ A perfect replacement for your car broken drive shaft CV boot clamp.
CV Joint Ear Clamp Banding Tool
▪ Type: 2 Kinds
▪ Material: Carbon Steel Jaw and Non-Slip Grip Handle
▪ The plier head is hardened. Rust and corrosion resistant.
▪ Non-slip insulated handles, allowing you to get the job done comfortably and efficiently.
▪ Applications: Widely used on CV boots, coolant and fuel lines, air pressure systems, compressors and other cooling system hoses. | Plier works on steering gear gaiters and fuel hoses on most cars.
Ear Clamp Plier
▪ Length: 8.96 in
▪ Jaw Max. Opening: 1.14 in
▪ Slim Head Design: The plier could easily enter in confined areas and will not damage the press points on the ear clamps.
▪ For simple and reliable clamping of single ear hose clamps and double ear clamps.
▪ Tip: Little oil on the the surface to keep the pliers free of rust, it will not effect the function. Just wipe it clean with a rag or old towel.
CV Joint Clamp Plier
▪ Length: 8.76 in
▪ Handles on both side are able to rotate 360 degree.
▪ With built-in cutters and winders, the banding can be tightened and cut quickly and effectively.
▪ Installation:
1. Wrap free-end clamps 3/8"" or 1/4"" roll band and clip around and clip around boot.
2. Place a 1/2"" ratchet wrench on the winding mandrel and turn. When sufficient tension has been applied, rotate the tool over the boot, bending the band back onto the clip.
3.It applies tension and has a built-in cutter.
4. To complete clamping, fold down the remaining tail of the band into the clip and secure it by tapping down the ears of the clip.