Shopping Cart

Your cart is empty.

Your cart is empty.

GOLD DEER 2 Sets Needle Test Probes 600V/10A Piercing Needle Non-Destructive Test Test Probe Pins Meter Probes Needle Multimeter Probes Test Probe Adapter Set for Multimeter Leads Electrical Testing

4.5 (4) Write Review
Free shipping on orders over $29.99

$11.01

$ 5 .75 $5.75

In Stock

About this item

  • Packing and size: 4PCS test probes + 4PCS sheaths, well packed; total length is about 84.5mm, test pin length is 34.5mm.
  • Application:The Probe Test Kit makes it easy and effective to check circuits and pierce the insulation of wires. It is very portable and lightweight tool for reverse probing wire harness connectors, automotive sensors and other test probe applications. Such as automotive industry, HVAC, electrical, marine, etc.
  • Design:The 2mm diameter is suitable for most multimeters and test leads, plug the test probe into the multimeter pen and it can be used directly with the multimeter to make some data measurements.
  • High Material:Made of high-quality nickel-plated copper with high sensitivity, accuracy and stability.CAT II: 600V/10A.
  • Safety: The anti-break soft-grip handle is made of insulated, flame-retardant material to ensure your safety during testing.


Product Description

1
2
3

Mike gray
Reviewed in Canada on September 15, 2024
Fitting leads tight so far.
Lisa
Reviewed in Canada on July 5, 2024
Does what it needs to do.
Stuart Hall
Reviewed in Canada on February 18, 2024
I started using these and I really liked them, they worked great and felt like they were good quality. These fit well on all of my diferent meter leads too. But the needle point is not crimped well inside the plastic casing allowing the needle to spin and actually cause there to be no continuity from the probe tip to the meter lead. I have to spin it around to get it to make a connection again. Otherwise the constrction is decent and they could work really well if the connection to the probe was better.
Ryan
Reviewed in Canada on December 2, 2024
Just bought these recently for my Fluke multimeter as they were much cheaper than the Fluke ones and figured they were just as good which they are! tested them right away and got accurate readings consistently. Very handy for getting voltage readings on all sorts of small pins on wiring harness applications or circuit board work. Great purchase overall!