Shopping Cart

Your cart is empty.

Your cart is empty.

PTC Heating Element, Aluminum Housing Ceramic Thermostatic Heater Plate with 5.9 inch Leading Wire Length 12V 60℃

4.4 (6) Write Review
Free shipping on orders over $29.99

$12.24

$ 5 .75 $5.75

In Stock

1.Size:12v 60℃


About this item

  • Aluminum Shell: The product shell is made of aluminum, with surface insulation design, safe to use, long-term dry heat, and high reliability.
  • Wide Range of Applications: This product is widely used in air conditioners, electric heating, automobiles, air curtains, humidifiers, dryers, etc. It can also be used for preheating of automobiles and electronic components.
  • Quick Response: PTC quickly converts electrical energy into heat energy after power-on, and conducts it to the surface of the aluminum shell within 10S
  • Constant Temperature Heating: Using ceramic constant temperature heating technology, continuous output heat, automatic constant temperature work. Supplied with a 15cm long , it is high temperature resistant and can be easily used to heat solids and gases.
  • Long Service Life: 7*24 hours of uninterrupted work, continuous supply of heat source for more than 20,000 hours


Specification:
Material: Aluminum
Heating Material: PTC Thermistors
Heating Mode: Heat through the of air or direct contact with an object
Material: High temperature rubber wire
Leading Wire Length: Approx. 15cm / 5.9 inch
Size: Approx. 60*28*7mm / 2.4*1.1*0.3in
Weight: Approx. 26g / 0.9 oz
Type:(Optional)
Package list:
1 * PTC Heating Plate
Note:
1.The power of PTC heating plate is not fixed. In a certain range, the better the heat dissipation, the greater the power.
2.Low voltage products not only need to meet their voltage, but also need to pay attention to the current.
3.If the power supply current can not meet the impact current of the product, the product will be slowly warming up, low temperature, or even short circuit.
4.Cannot be directly immersed in water or liquid.


old hunter
Reviewed in Canada on January 26, 2024
Useless junk!!! I purchased two of these. One draws .5a, the other .4 @ 14 volts battery power. 31C, after an hour. All values below specs. They are mounted on a 1/4" aluminum plate with thermal paste and all connections are soldered. No excuses for bad QC.
erischilde
Reviewed in Canada on June 5, 2023
got it, grabbed a power supply, hooked up my multimeter, pulling all of 25 milliamps at the best.200 Celcius? Couldn't get 20.Tried "contact with another object" to pull heat, no increased current draw, no increased heat.I imagine that it's really a crapshot if you get one that works or doesn't; i wasn't expecting much knowing the complete lack of QA on Amazon regarding 3rd party stuff like this, i figured i'd give it a shot and test it for the price. Not useful for anything.
Lucy
Reviewed in Canada on April 29, 2023
This 12v heating element is ONLY 5 watts and not nearly hot enough to make a small incubator.
Ray
Reviewed in Canada on October 19, 2022
Dont heat up at all,Have 3 of them connected in parallel to 12v, total of 1.2 amps when on for a few minutes.Supposedly they should be approx 50w each and in reality they are only putting out 3-5wUseless for my applicarion
Gerry C.
Reviewed in Canada on December 4, 2021
Consistent 50W draw (with a good heat sink) ... great quality ... thx
Ricky Gagnon
Reviewed in Canada on January 16, 2021
Solid construction