Shopping Cart

Your cart is empty.

Your cart is empty.

uxcell 6003-2RS Ball Bearing 17mm x 35mm x 10mm Double Sealed 180103 Deep Groove Bearings High Carbon Steel Z1 (Pack of 2)

4.7 (5) Write Review
Free shipping on orders over $29.99

$8.14

$ 4 .31 $4.31

In Stock

About this item

  • Size: 6003-2RS (Inner Dia.=17mm, Outer Dia.=35mm, Thickness=10mm)
  • Sealed on BOTH SIDES of the bearing to keep lubricant in. Suitable for complex environment
  • Made from High Carbon Steel, durability and resistance to under heavy loads
  • ABEC Tolerance 1 (P0), Z1 Noise Level for most general use
  • Same As 6003-2RS / 180103. Pre-Lubricated, Easy to maintain


NOTE：

Please refer to the picture and select right type of bearings before your order (Sealed or Shield on BOTH or SINGLE side of the bearing). Suffix on the bearing just for differentiating between Sealed and Shield type of bearing. It would not affect the use of our product.

Description:

  • Deep Groove Ball Bearings are one of the most widely used rolling bearings. They are used to accommodate radial and axial loads in both directions.
  • Suitable for all kinds of industrial equipment, micro motor, small rotary motor, office equipment and so on.
  • With small friction and high-limit speed, Uxcell's Deep Groove Ball Bearings are cost-effective and require little maintenance.
  • These cost-effective bearings are widely used in areas with low requirements for Mohs hardness.
  • Single-row, pre-lubricated, normal accuracy.

Selection Guide:

Shields (Designation Suffix Z/ZZ) - High speed. Protect from dirt and debris.

Sealed (Designation SuffixRS/2RS) - Made of sheet steel reinforced NBR (oil- and liquid-resistant). Lower limit speed than Shield Bearings.

Specification:

Model: 6003-2RS

Sealed Type: Double Sealed

Material:High Carbon Steel

Heat Treatment:Quenching

Hardness: HRC50-55

Cage Material: Stamping Steel

Inner Diameter (d): 17mm

Outer Diameter (D): 35mm

Thickness (B): 10mm

Dynamic Load Rating (Cr): 6kN

Static Load Rating (Cor): 3.25kN

Accuracy Class: P0 (ABEC-1)

Noise Level: Z1

Number of Pack: 2 Pcs

Weight: 80g


stu
August 9, 2025
Used these as part of a rebuild of a 7 x 12 metal saw.
dad7
July 31, 2025
Installed in my Dremel grinder and runs very well.
christopher pruitt
June 11, 2025
Awesome
Ronan Falce
December 24, 2024
No abec rating, not that id trust it if there was one. Work fine for now, only time will tell how they hold up. Little in n out play but no side to side.
Karl A
December 11, 2024
Failed after 300 miles of use in an alternator…Small end support, not under any significant load and it still failed and started to make snap crackle pop noises after 300 miles of use.These are Just crap.